NESS 4G 106-490NS DIALLER UNLOCKED 4G GEN3 For Telstra Vodafone Optus and etc

106-490NS 4G DIALLER GEN3 UNLOCKED - NO SIM

The Ness 4G Dialler provides a 4G pathway for alarm diallers to communicate in the absence of a landline.

This unit provides support for any dialler that reports to any Central Monitoring Station (without a need for any special control room receiver) or can dial an alarm event to a personal number, in the same fashion as it would if a landline was available.

Built in backup battery allows operation in the event of brief mains interruptions.

No programming of the device is required, just plug and go.

Supplied with plug pack power supply, telephone lead, 4G Antenna.

This model is supplied without a SIM card and can be used with your own SIM.

It requires a full-size SIM which must be sourced and installed by the purchaser.

IMPORTANT NOTES

• This product is designed to provide a cellular pathway for alarm control panels with landline diallers in the absence of landlines.
• Not intended for industrial use.
• Not recommended for use in lift cars or other non-stationary situations.
• Ensure that the location has adequate cellular signal and test operation after installation.
• The unit must be tested weekly to verify cellular reception and correct operation.
• The 12V plug pack supplied must be used. Do not connect to an unregulated or 'noisy' power supply.
• If you are upgrading from a 3G model, please replace the old antenna with the 4G antenna supplied.

Ship out the order within 24-48 hours.

Change of mind:
Customer can return the item if purchased by mistake within 14 days of the customer’s order being received.

Change of mind returns will only be eligible for a refund on the product’s sale price within receiving the item'. Return postage is paid by the customer.

Warranty

Without prejudice and to the extent allowed by the Trade Practices Act 1974, The Australian Consumer Law and Competition and Consumer Act 2010, all hardware sold by MAD Electronics Australia is covered by one year limited warranty and is also backed by Australian manufacturer warranty. Where the manufacturer warranty period exceeds one year, we will advise the customer to contact the manufacturer directly for warranty support after the first year of purchase. Due to the nature of consumables products and software, they are not returnable or refundable items.

Any defective products purchased from MAD Electronics Australia and affiliates that fall within the warranty period provided will be covered, unless they fall within the following conditions:

· Physical Damage on the product not caused in the event during transit or Dead on Arrival (DOA) but caused due to mishandling, incorrect use of product for its purposes, improper installation of product, by accident, insect or vermin infestation, improper method or failure to maintain service and handle the item with reasonable care.

· The product has been modified using unauthorised methods. Any modifications on the product including physical and software modifications using third party unauthorised software such as third party firmware updates will void the warranty of products.
· The warranty seal or serial number of the item has been tampered with.
· The item has been serviced by another party other than madelectronics
· Consequential loss including but not limited to data, programs, software or other information stored on storage products, computer or laptop systems.
· Software

Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.