Seachem Phosguard 1L (SC18708)

Seachem Phosguard 1L

• Removes silicate and phosphate
• Spherical for optimal hydrodynamics
• Irreversible binding

PhosGuard(TM) rapidly removes phosphate and silicate from marine and freshwater aquaria. It is not recommended for phosphate buffered freshwater. PhosGuard(TM) is highly porous for high capacity and bead-shaped for optimum water flow.

Aluminum Oxide, Soluble Aluminum, and Coral Toxicity

In recent years, there has been speculation that aluminum oxide based phosphate removers like PhosGuard(TM) release aluminum into the water and subsequently damage corals. The evidence to support this claim was largely anecdotal.

So, through a series of controlled experiments in both freshwater and saltwater, we intended to address both the question of aluminum solubility and aluminum toxicity. The results of these experiments show that under reef conditions (pH near 8) there is no detectable soluble aluminum released from alumina. Under conditions of low pH and high dosage levels, soluble aluminum can be released from alumina; at three times the label dosage rate, we detected 0.2 mg/L aluminum at a pH of 5.3.

Additionally, aluminum oxide is not easily absorbed into the cell to cause negative reactions. Even at three times the dose of PhosGuard(TM), soft-bodied corals such as Sarcophyton remain unaffected.

Directions

May generate heat on initial contact with water. Pre-wet by adding to a double volume of freshwater, followed by a rinse. For best results, PhosGuard(TM) should be rinsed before use and placed so as to maximize the flow of water through it but not so that it tumbles against itself in flow. It may be used in a canister filter, media chamber, box filter, or any high flow area of a trickle filter. Use of a filter bag is recommended. Use 85 mL (1/3 cup) for every 200 L (50 US gallons) saltwater or 400 L (100 US gallons) freshwater.

Leave product in place for 4 days, then test phosphate or silicate concentrations with either MultiTest(TM): Phosphate or MultiTest(TM): Silicate. If the concentration of the component you are trying to decrease has not dropped to around 0.02 mg/L, then replace the PhosGuard(TM), otherwise leave in place until levels begin to climb again. As long as concentrations remain under control, the product is not exhausted. Over treating is not recommended. PhosGuard(TM) is not an exchange resin and does not release anything into the water. It does not leach phosphate or silicate back into the water and may be removed, dried, and returned to service until exhausted. Continuous use of small quantities is better than intermittent use of larger quantities.

Sizes

100 mL, 250 mL, 500 mL, 1 L, 2 L, 4 L

We are more than happy to ship Australia wide. When you place an order we guarantee that your items will be shipped within 2 working days. If, for reasons beyond our control, we are unable to ship your order within 2 working days, you will receive an email informing you of the estimated delivery time-frame. At Aquarium Spare Parts we aim to ship your orders as efficiently as possible. If you have any queries or concerns regarding shipping time-frames or costs, please feel free to email us.

Due to the nature of the parts that we have available, it is difficult to calculate some shipping prices (as your order combinations vary). We do our best to provide you with accurate shipping prices, however if you are concerned about the shipping price - please contact us and we can double check it for you. All orders are shipped via Australia Post unless specified otherwise.

At Aquarium Spare Parts we strive to ensure that you are satisfied with the items that you receive. We do this by providing as much detailed and accurate information about the products that you are purchasing. We want you to love what you have ordered. If something isn’t quite right or if you’re not satisfied with the items that you have received, we want you to let us know. We encourage you to do this as soon as possible.

It is our intention to ensure you are satisfied with your entire online experience.

If you find you are not satisfied with an item that you have received, you are welcome to return it to us. We accept returns within 365 days of purchase when the item is in its original condition, with packaging & labels, unopened and unused. This does not include food, live plants or any other perishable items.

All returns within the 365 day period are required to include your receipt. Once we have received and accepted the returned item, a credit will be issued. Shipping or return shipping prices are not included in the refunded price.

You need to include the Return & Exchange Form along with the item(s) you are returning in their original condition and any packaging that came with it. Please note that whilst individual packaging can be opened, the box or container must not be ripped, damaged or the seals removed in order to be eligible for a refund or exchange.