PK'S LOOP ANTENNA Hd Series Remote Tuned Loop Fringe Antenna -Incl 10M Cable
PK Loop Antennas are proudly designed and manufactured inAustralia
An outdoor AM Loop antenna with remote tuning for buildings constructed with steel roofs and frames ( like sheds or caravans) or those with re-inforced concrete.
The Loop mounts outdoors and a single co axial cable connects it to the tuning control box.
There is an output for a wired connection to your AM radio / receivers external antenna and ground terminals
The tuning system is sharp and peaks right on station, boosting weak signals whilst rejecting interference and enhancing reception quality.
Supplied Accessories
- 1 x Loop antenna,control box with inbuilt 9V battery holder and instructions
- 1 x Loop cable, a 10m Coax cable pre-fitted with "F" connectors
- 1 x 1m - F- connect to open ends cable for radio / receiver antenna - ground terminals
- 1 x L-mount bracket with screws to fit it to the loop base
Specifications:
|
AM Band | 525 to 1725KHz |
|
IP56 rated PVC | Paintable |
|
40cm - 16" Dia | |
|
9v Alkaline battery | ( NOT SUPPLIED ) |
Set Up
- Connect the coax cable between the Loop antenna and the control box connecter marked "LOOP"
- Connect your Radio / Receiver to the connector marked "Radio" on the control box
- Insert a fresh 9v Alkaline battery ( Not supplied ) into the control box
- Tune your Radio to the desired Stations' frequency
- Slowly turn the manual tune control to the point of strongest reception
- Orientate the Loop Antenna to obtain the clearest reception; Edge on towards the transmitter is best.
Ship out the order within 24-48 hours.
Estimated Delivery Time Frame: 2 - 15 business daysChange of mind:
Customer can return the item if purchased by mistake within 14 days of the customer’s order being received.
Change of mind returns will only be eligible for a refund on the product’s sale price within receiving the item'. Return postage is paid by the customer.
Warranty
Without prejudice and to the extent allowed by the Trade Practices Act 1974, The Australian Consumer Law and Competition and Consumer Act 2010, all hardware sold by MAD Electronics Australia is covered by one year limited warranty and is also backed by Australian manufacturer warranty. Where the manufacturer warranty period exceeds one year, we will advise the customer to contact the manufacturer directly for warranty support after the first year of purchase. Due to the nature of consumables products and software, they are not returnable or refundable items.
Any defective products purchased from MAD Electronics Australia and affiliates that fall within the warranty period provided will be covered, unless they fall within the following conditions:
· Physical Damage on the product not caused in the event during transit or Dead on Arrival (DOA) but caused due to mishandling, incorrect use of product for its purposes, improper installation of product, by accident, insect or vermin infestation, improper method or failure to maintain service and handle the item with reasonable care.
· The product has been modified using unauthorised methods. Any modifications on the product including physical and software modifications using third party unauthorised software such as third party firmware updates will void the warranty of products.
· The warranty seal or serial number of the item has been tampered with.
· The item has been serviced by another party other than madelectronics
· Consequential loss including but not limited to data, programs, software or other information stored on storage products, computer or laptop systems.
· Software
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
